How do I paint over stained wood without having to sand?

I have a table and chair set that is very ornate. It is currently stained with high gloss over it. Is it possible to redo the set without having to sand everything? What products can I use and what is the best type of paint? I want to paint the table and chairs a simple cream color. If it is not possible to skip the sanding, do I need to sand every little thing or just the basics? Thanks!How do I paint over stained wood without having to sand?
If it's as ornate as you say, painting will take away a lot of the beauty from that. But that's just personal preference.





If the surface is really glossy, it will be difficult to get paint to adhere well. You'll need to 'rough up' the surface. You might try some of the flexible sanding pads or steel wool. They'll get into the curves and crevices better. Also consider spray paint. It will be easier than using a brush. I would go with a good enamel paint. Something that's tough but easy to clean.How do I paint over stained wood without having to sand?
You really do need to spend the time on light sanding or the paint will scratch off every time the chair/table is scraped with anything. You will be very disappointed after a very short time.





To make the sanding easier, I would suggest a flexible, thin sanding block. You can find these at all paint stores, home centers, probably even Walmart.


They are about 4';x5';x3/8'; thick. A bit rough on the sides. you can manipulate this around the curves and detail on the chairs.


You only have to do a light sanding that scratches/breaks the surface of the stain. The ';scratches'; allow the new paint to have something to hold onto.


After sanding, wipe all sanding dust off.





Then I think you should use a good quality primer as your first coat.


I like Kilz2 but you may be able to find something better that has better adhesion to shiny surfaces.


Expect to pay $15-20. for the primer.





Then apply the top coat in the color of your choice. Using a satin or semi-gloss sheen will work best on chairs.


You need to buy 1 gallon of each primer and paint. Buy latex (water-base).


Look for a good quality paint too. Olympic, behr, valspar, sherwin williams. Expect to pay $20-30. for paint.


Good luck
yes you should remove the finish first before painting. get a can of furniture stripper there is no sanding involved and it is very affective. be careful to follow the instructions because it is also very corrosive. If your not into that you could sand the surface a little so the paint will stick better.
heres the easiest and cheapest way to do what you want. go to a paint store ( Sherwin or Porter) don't tell them anything because they will tell you anything. just get a small box of TSP. trisodiumphosphate. mix as directed in warm water. clean as directed. then apply 2 coats of any oil base trim paint. you may want to thin the paint a little with some mineral spirits. may take three coats. high gloss,semi gloss, or satin. your choice. see,much easier.
Use Krylon acrylic lacquer (indoor/outdoor) spray paint for stained or painted wood,


(also for metal) it bonds on a molecular level so you don't have to sand, just make sure the surface is free of dirt/grease.


http://www.kpg-industrial.com/products/5鈥?/a> - available hardware/home improvement (ivory/dover white)